BLOX Racing Subaru Xtreme Titanium Wheel Studs 12 x 1.25mm - Set of 10

Titanium Extended Wheel Stud, M12x1.25mm - Set of 10 - Subaru Fitment

Features

Manufactured From Ti64 Titanium

Reduce Rotational Mass

Corrosion & Fatigue Resistant

Each Extended Stud Weighs Approximately 34 Grams

Wheel Stud Specs

Thread pitch: 12x1.25mm

Total length: 78.85mm

Thread length: 58mm

Head diameter: 20mm

Base thickness: 2.85mm

We are proud to introduce a solution to common wheel stud failures - our new Blox Racing Xtreme Titanium Wheel Studs. These lightweight wheel studs are manufactured from aerospace grade Ti64 Titanium. We chose Titanium for our Xtreme line, because it is resistant to the constant heating and cooling cycles common to wheels that will destroy steel studs and bolts. Our Xtreme Wheel Studs will not corrode or rust and they offer 50% in weight savings over old school steel studs. Upgrade to our New Titanium Wheel Studs today and never get a failed stud again!

WHAT YOU NEED TO KNOW:

> Subaru models up to 2007 do not require the hub to be pressed out to install Blox Xtreme Titanium Wheels Studs; 2008+ models require the hub to be removed.

> If you use our titanium studs and titanium lug nuts you must use generous amounts of anti-sieze to avoid galling.

> Precision Ti64 spline results in no welding or spinning of the stud in the hub.

> Each Extended Stud weighs 34 grams. Compare to the factory wheel stud weight of 37 grams and ARP wheel studs of 68+ grams.

Extended wheel studs are available in sets of 10 and single piece set.

Single-piece wheel studs are available and are ideal for when replacing only a few old or damaged studs.

FYI: Wheel studs must properly be pressed in using a mechanical or hydraulic press.